Bimba STP-10 Manual do Utilizador descarregar pdf (Página 38)

STP-10 Hardware Manual

Alarm Codes

In the event of an error, the red and green LEDs on the main board will ash in alternating red-green patterns as shown below.

The pattern repeats until the alarm is cleared.

Front View

X COMMON

X3 / Enable

X5 / CWJOG

X4 / Alarm Reset

Analog IN2

Analog IN1

X2 / DIR-

X2 / DIR+

X1 / STEP +

X1 / STEP -

GND

+5V OUT

Y COMMON

Y3 / FAULT

Y2 / MOTION

Y1 / BRAKE

X6 / CCWJOG

IN/OUT

X8/CCWLIMIT+

X8/CCWLIMIT-

X7/CWLIMIT-

X7/CWLIMIT+

Y4-

Y4+

RX+

–

TX+

GND

RS-485/422

DB-25 I/O Connector

Connector Diagrams

encoder Z+ (5)

do not connect (10)

encoder B- (4)

do not connect (9)

encoder B+ (3)

do not connect (13)

do not connect (14)

shield (15)

(12) do not connect

(11) do not connect

(6) encoder Z-

(1) encoder A+

(7) +5VDC 200mA

(2) encoder A-

(8) GND

Front View

Code Error

solid green no alarm, motor disabled

flashing green no alarm, motor enabled

1 red, 1 green motor stall (optional encoder only)

1 red, 2 green move attempted while drive disabled

2 red, 1 green ccw limit

2 red, 2 green cw limit

3 red, 1 green drive overheating

3 red, 2 green internal voltage out of range

3 red, 3 green blank Q segment

4 red, 1 green power supply overvoltage

4 red, 2 green power supply undervoltage

4 red, 3 green bad instruction in Si program

5 red, 1 green over current / short circuit

5 red, 2 green motor resistance out of range

6 red, 1 green open motor winding

6 red, 2 green bad encoder signal (optional encoder only)

7 red, 1 green serial communication error

7 red, 2 green flash memory error

8 red, 1 green internal voltage out of range

HD-15 Encoder Connector

1 2 ... 33 34 35 36 37 38 39

Comentários a estes Manuais

Sem comentários

Bimba STP-10 Manual do Utilizador Página 38

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Bimba STP-10